Installation – Whiteboards

Installing Your Whiteboard

Tools You Will Need

  • Drill & drill bits,
  • Philips head screw driver,
  • Tape measure,
  • Pencil
  • Level
  • Hammer
  • Allen Key



INSTALLATION GUIDE

Get your board set up, following our easy step-by-step guide!

 

Step One Step One Position the whiteboard on the wall. Using a level check that it is level. Mark the wall where the fixings will go, using the holes in the glass as a guide.
Step Two Step Two Drill holes in the wall using an 8mm drill bit.
Step Three Step Three Hammer the tip of the wall mates into each hole. Screw the wall mate in until firm.
Step Four Step Four Remove threaded screw and discard.
Step Five Step Five Install Standoff Fixings by screwing the long threaded rod into the wall mate by hand.
Step Six Step Six Position the holes in the whiteboard over the fixings and secure the whiteboard on the wall. Screw the fixing cap onto the thread that is projecting from each hole and tighten.

Customer Reviews